US Wall Toggle Switch Cover for Philips Hue Dimmer Switch v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cover plate for a standard US 1-gang toggle switch, using the device-mount holes, for a Philips Hue Dimmer Switch V2
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement cover plate for a standard US 1-gang wall toggle switch (using the device mount holes, not the gang mount) that accepts the decorative mounting plate from a Philips Hue Dimmer Switch v2 (mine identifies itself as a "Signify Netherlands B.V. RWL022").
It leaves the underlying switch completely alone, so you can still turn the switch off, but it prevents someone from accidentally flipping it (and turning off the attached smart devices) when they walk into the room.
Print this in any filament you like, back-side down, with "normal" supports enabled, and a pretty low percentage infill (I used 10% gyroid, and even that was probably overkill).
The lip around the edge is intentional; it allows the plate to rest against the wall evenly even if the gang box is skewed from the drywall, and because it's against the wall, it's okay if your support tuning is bad and you get a terrible surface out of it. (In fact, the only surface that will be visible when it's mounted is the outside shell.) Feel free to trim the lip off if you've got a perfectly-mounted switch and smooth wall surface.