Efog Tech Endgame wrist rest
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wrist rest for the Endgame trackball.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 1
- Wyświetlenia
- 37
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wrist rest for Efog Tech's Endgame trackball (https://efog.tech/products/endgame-trackball-complete-diy-kit).
It's made of two parts which I printed as such:
The bottom piece which holds the trackball, allowing you to transport it and the wrist rest as one unit. Printed in +- 55g of PETG Matte with 25% adaptive cubic which seems fine. PLA will probably work too here.
The cushion. I printed this in +- 33g of TPU 85A using +-7% Gyroid infill. This resulted in a soft but supportive cushion for me, but this is highly personal and might take adjusting. If you use harder TPUs like 95A, you probably want to start at 5% infill instead. You could even consider more infill in the bottom and less in the top. I also made the top surface face the build plate so I got a nice surface finish on a textured plate.