1 / 1
Radial Drainage Plant Saucer – 2 Sizes (40 mm & 145 mm Pots) — zdjęcie 1

Radial Drainage Plant Saucer – 2 Sizes (40 mm & 145 mm Pots)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lightweight plant saucer with radial ribs for better drainage and airflow. Two sizes, easy to print, no supports needed.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Radial Drainage Plant Saucer – 2 Sizes

A simple, low-profile plant saucer designed to collect excess water while keeping the bottom of your plant pot slightly elevated.

Instead of concentric rings, this design uses 10 radial support ribs to create open channels beneath the pot, allowing water to spread across the tray.

Features

  • Two sizes for different plant pots

  • 10 radial support ribs

  • 1.2 mm walls and bottom

  • Closed bottom to collect excess water

  • No supports required

  • Designed for easy FDM printing

Available sizes

Version

Pot base diameter

Saucer diameter

Height

Mini

40 mm

52 mm

8 mm

Large

145 mm

156.6 mm

10.8 mm

Recommended Print Settings

  • Material: PETG recommended; PLA also suitable for indoor testing

  • Nozzle: 0.4 mm

  • Layer height: 0.2 mm

  • Wall perimeters: approximately 3, depending on extrusion width

  • Bottom solid layers: at least 6

  • Supports: No

  • Orientation: Flat on the print bed, open side up

Note: The STL models have been checked for closed, manifold geometry but have not yet been physically print-tested. Check water tightness before placing them on furniture that may be damaged by water.

Feedback and photos of your prints are welcome!

Tagi