Radial Drainage Plant Saucer – 2 Sizes (40 mm & 145 mm Pots)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lightweight plant saucer with radial ribs for better drainage and airflow. Two sizes, easy to print, no supports needed.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
Radial Drainage Plant Saucer – 2 Sizes
A simple, low-profile plant saucer designed to collect excess water while keeping the bottom of your plant pot slightly elevated.
Instead of concentric rings, this design uses 10 radial support ribs to create open channels beneath the pot, allowing water to spread across the tray.
Features
Two sizes for different plant pots
10 radial support ribs
1.2 mm walls and bottom
Closed bottom to collect excess water
No supports required
Designed for easy FDM printing
Available sizes
Version | Pot base diameter | Saucer diameter | Height |
|---|---|---|---|
Mini | 40 mm | 52 mm | 8 mm |
Large | 145 mm | 156.6 mm | 10.8 mm |
Recommended Print Settings
Material: PETG recommended; PLA also suitable for indoor testing
Nozzle: 0.4 mm
Layer height: 0.2 mm
Wall perimeters: approximately 3, depending on extrusion width
Bottom solid layers: at least 6
Supports: No
Orientation: Flat on the print bed, open side up
Note: The STL models have been checked for closed, manifold geometry but have not yet been physically print-tested. Check water tightness before placing them on furniture that may be damaged by water.
Feedback and photos of your prints are welcome!