Radxa X4 adapter for passive Noctua NH-L9x65 cooler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter allows to mount a Noctua NH-L9x65 cooler passive to a Radxa X4 SBC.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter allows to mount a Noctua NH-L9x65 cooler passive to a Radxa X4 SBC. With the cooler flat on the table and power set to 15 watts the N100 reached max 86°C under Cinebench R2024. The reported power consumption was between 12-13w at 2.9Ghz sustained.
Print settings
- Print material: ASA, ABS or other heat resistant material.
- layer height 0.2mm, 0.4mm nozzle, 4 layers wall thickness, top and bottom layers and 40%+ infill
Parts needed
- 4 x M3x10 pan head Screw, the head should not be higher than 2.1mm
- 4 x M3 nut
- 4 x M2.5 threaded Hex Standoff screw for SBCs.
Installation
- Unscrew the 4 M3 screws on the Noctua cooler and remove the two black metal parts. Unfortunately the M3x6mm Noctua screws are too short.
- Check after printing if the M2.5 threaded Hex Standoff screw fits well into the adapter holes
- Put the adapter on the Noctua NH-L9x65 and use the M3x10 and nuts to screw it on.
- Place your favorite TIM on the CPU die of the N100 and place it carefully on the adapter. Use the M2.5 threaded Hex Standoff screws to fix it and put some slight pressure between the cooler plate and the CPU die. On the 4th hex standoff screw the threaded shaft needs to be shortened to about 3mm length. This in order to not touch the cooler.
This adapter is made to the measurements of my Radxa X4. If it does not perfectly fit yours, let me know and I can make it fit.