Cat containment/enclosure fence
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cat containment/enclosure with security improvements over the original
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed from the original because I ran into a few issues with the setup after a few years of use, and a cat that kept testing it.
I printed this on a Core One + Gen 2 without any issues. Suggested print settings:
Place the mounts with the back side on the bed so they print without supports.
Place the bars diagonally on the bed so they fit on the Core One.
Use PETG or ASA for outdoor durability.
Print with the 0.20 mm STRUCTURAL profile.
Use 5 perimeters on all parts, so the hooks and holes are fully solid and stronger.
Set top/bottom layers to 5 or 6.
Use 40% gyroid infill for the mounts and 30% gyroid for the bars.
These settings worked perfectly for me. With PETG, the dovetail joints on the bar fit very snugly. I needed a hammer to get the last millimeter in, so do this carefully.