Generative Art Pendant – Waveshare ESP32-S3 1.69"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A printed pendant case for the Waveshare ESP32-S3-Touch-LCD-1.69 V2, running a generative art animation you tap to pause
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The animation on screen differs from the guide's starter sketch.
A pendant case for the Waveshare ESP32-S3-Touch-LCD-1.69 V2. The board runs a generative art animation: colored lines and rings that keep moving and shifting hue. Tap the screen to pause or resume it.
The display and touch panel are built into the board, so there is nothing to wire: plug in a small LiPo and it runs on battery. The guide estimates roughly four hours from a 400 mAh battery.
Parts
Waveshare ESP32-S3-Touch-LCD-1.69 V2
3.7 V 400 mAh LiPo (check your battery's connector and polarity against the board's battery socket)
A cord; keep metal chains off the board contacts
Printing
One part: schematikJEWLERX.stl, 40.6 × 45.6 × 16.4 mm, with a loop for the cord. OrcaSlicer 2.4.2 estimates about 12 min on a Bambu Lab P1S (0.4 mm nozzle, 0.20 mm Standard, Bambu PLA Basic, auto-orient). With supports off it reports a floating cantilever, so turn supports on or re-orient the part.
The case walls have no opening for the USB-C port.
Assembly
Leave the screen's protective film on until the board is in the case.
Check your battery's connector and polarity, then plug it into the board's battery socket. Push on the plug, not the wires.
Fit the board and battery into the case, screen facing out. Keep the battery flat and untwisted, with a small strain-relief loop in its wires.
Charge over USB-C with the board out of the case: the case has no USB-C opening, and the guide warns against charging the LiPo sealed in a case.
Unplug the cable and the artwork keeps running from the battery. Tap the screen to pause or resume.
Full guide with wiring and firmware: https://www.schematik.io/projects/generative-art-pendant-gyge
Firmware and wiring guide generated with Schematik, our AI hardware tool; the enclosure was modelled by hand.