Kit Card Fire Truck - Snap-Fit Toy, Raising Ladder, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One flat print: snap out the parts and build a fire truck with rolling wheels and a raising ladder. No glue or supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — NoDerivatives
A complete fire truck that prints as one flat card. Snap the parts off the frame, slot them together and you have a little fire engine with rolling wheels and a ladder that tilts up and down. No glue, no screws and no supports.
Why it's fun: it prints in well under an hour, the parts interlock egg-crate style so the build feels like a real model kit, and the finished truck actually rolls. Great for kids, desk toys, party favours or a quick gift.
Parts on the card (16 total): 2 side panels, 1 center frame with ladder tower, 1 rear wall, 1 cab back, 1 windshield, 1 front bumper, 1 roof bar with light bar, 1 ladder, 1 ladder pivot pin, 4 wheels and 2 square axles.
Card size: about 115 x 98 mm, 2.5 mm thick. Assembled truck: about 55 mm long and 24 mm wide (wheels add a little), around 45 mm tall with the ladder raised.
Assembly
Step 1: Twist or clip each part off the card and trim any leftover gate nubs flush with a knife, file or flush cutters.
Step 2: Stand the rear wall, cab back, windshield and front bumper upright with their slots facing up.
Step 3: Lower the center frame into the middle slots of the rear wall and cab back. The tall tower goes at the back.
Step 4: Press both side panels down onto all four cross pieces so the slots lock together. The sloped end of each panel is the front of the cab.
Step 5: Press the roof bar down onto the notches on top of the cab, with the light bar on the left.
Step 6: Push one wheel onto each axle (square press fit), snap the axles up into the round seats under the body, then press on the other two wheels. Leave a small gap so they spin freely.
Step 7: Snap the pivot pin down into the seat at the top of the tower with its wide head on the outside, then press the ladder's square hole onto the pin. The ladder now tilts up and down.
Print settings
PLA, 0.2 mm layers, 2 to 3 walls, 15 to 20% infill. No supports needed, the whole card prints flat. A brim is optional and only helps if your bed adhesion is weak. Roughly 30 to 45 minutes on a typical modern printer.
Tips: the slots are 2.65 mm for 2.5 mm parts. If a joint is too tight, give the slot a quick pass with a file; if your printer runs loose, a drop of glue in the joints is fine. Wheel and axle fits are snug press fits on purpose.
If you print one, please post a Make with a photo, I'd love to see your fire trucks! Check my profile for the rest of the Kit Card series: race car, monster truck, tractor, excavator, helicopter, biplane and more.
