1 / 4
LED Noodle Earrings - cr1025 battery holder — zdjęcie 1
1 / 4

LED Noodle Earrings - cr1025 battery holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A holder for a tiny cr1025 battery with holes for LEDs. Can be used to make glowing LED noodle earrings.

Ocena
0 / 5
Polubienia
89
Pobrania
43
Wydruki
0
Wyświetlenia
1128
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

These LED earrings are super simple to make and very eye-catching in low light. Perfect for parties, raves, festivals or just being fabulous at home :)

No soldering required!

You will need:

  1. Noodle LEDs (like these ones)

  2. CR1025 coin cell batteries

  3. Earring studs with flat fronts

  4. 3D printed holder

  5. Super glue

Simply insert the ends of the noodle LED so that the positive leg is wedged against the positive side of the battery and the negative leg is against the negative side. Use super glue to fix them in place if not wedged tight enough. Insert a thin piece of plastic between a leg and the battery to act as a switch if required.

Print Settings:

20% infill, support required (print upright)

Tagi