iPhone Duo Riser Adapter for Anker 313 / PowerWave Wireless Charger Stand (A2524)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A snap-on riser block that lifts the iPhone Duo on the Anker 313 / PowerWave Stand.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The iPhone Duo sits too low on the stock Anker 313 Wireless Charger (A2524). Because of that height mismatch, the charging coils don't line up properly on the stand.
This one-piece adapter slips right over the charger's bottom lip to raise your phone. That extra height lines up the coils for steady wireless charging.
Design Highlights
Side retention tabs hug the charger's bottom ledge so the block won't slide around.
Open bottom cutout leaves the charger's front status LED clear and easy to see.
Flat geometry prints in one piece without any supports or cleanup.
Recommended Print Settings
Material: PLA or PETG
Layer Height: 0.20 mm
Perimeters / Walls: 2 to 3
Infill: 15% to 20% (Grid or Gyroid)
Supports: None needed
Orientation: Place the large flat face directly on the build plate