1 / 2
Holley in tank fuel pump Wire pass-thru bulkhead plug replacement — zdjęcie 1
1 / 2

Holley in tank fuel pump Wire pass-thru bulkhead plug replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replaces the stock wire pass-thru bulkhead plug which is prone to damage/defects.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
4
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Original plug with these Holley sniper/terminator EFI fuel pumps is prone to internal damage which causes the wire to heat up to dangerous temperatures. 

This 3d printed design uses the -2- original O-rings and it designed to pass thru 12 gauge wires. I used this in conjunction with the below wire kit.

This kit works great to replace your burnt/damaged wires: Summit Racing SUM-251011 Summit Racing™ Fuel Pump Wiring Kits | Summit Racing

You will need to use a fuel resistant filament.  I used carbon fiber reinforced Nylon.

DISCLAIMER: USE AT YOUR OWN RISK AND ENSURE TO TEST ANY FILAMENT AGAINST EXTENDED DIRECT FUEL CONTACT.

Tagi