Holley in tank fuel pump Wire pass-thru bulkhead plug replacement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replaces the stock wire pass-thru bulkhead plug which is prone to damage/defects.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Original plug with these Holley sniper/terminator EFI fuel pumps is prone to internal damage which causes the wire to heat up to dangerous temperatures.
This 3d printed design uses the -2- original O-rings and it designed to pass thru 12 gauge wires. I used this in conjunction with the below wire kit.
This kit works great to replace your burnt/damaged wires: Summit Racing SUM-251011 Summit Racing™ Fuel Pump Wiring Kits | Summit Racing
You will need to use a fuel resistant filament. I used carbon fiber reinforced Nylon.
DISCLAIMER: USE AT YOUR OWN RISK AND ENSURE TO TEST ANY FILAMENT AGAINST EXTENDED DIRECT FUEL CONTACT.
