HandCrank Washing Machine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small, portable machine to wash clothes without power!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
Introduction:
This is a small, beginner made model of a washing machine which is operated by hand cranking the drum. To use it, you will have to fill the drum 1/4 of the way full, add your soap/detergent and then shut the door. You will then take a rubber band of reasonable strength, put it around the handle and then loop the rubber band around the other end of the peg on the side of the machine. To dry clothes, empty the drum of any liquid and spin, this should be enough to speed up the drying process, but will not completely dry the clothes!
This machine has been simulated in testing in software to suit up to a load of 500 grams...
WARNING: THIS MACHINE HAS NOT BEEN PRINTED AND TESTED IN THE REAL LIFE, ONLY IN SIMULATIONS... THERE MAY BE SOME UNFORESEEN ISSUES WHICH WILL MEAN USER ADJUSTMENTS TO THE DESIGN MAY BE NEEDED!
Technical Specifications:
Machine outer shell: 200 by 200 by 200 (millimetres) (shell thickness of 2.5 millimetres)
Drum: 180 (in diameter) by 180 (in depth), measured in millimetres (thickness of 2.5 millimetres)
Assembly Instructions:
After printing a shell, push the drum through the front fascia of the machine.
Secure the drum by pushing the handle through the hole on the back of the machine casing and tightening the handle to the drum by using the nut provided in the files. Then test if the rotating handle anti-clockwise rotates the drum freely, if it does not... loosen the nut ever so slightly and try again till the drum rotates freely with the handle. Then drill the nut in place into the handle (or alternatively hot glue the nut and handle together)...
After this, print the seal in flexible TPU is possible and then stick this using glue to the outer fascia of the shell around the opening for the machine.
Now, take the front door. Slide the door across the hinge and then push down, locking the door in place to the hinge.
Since there is no lock on this machine, to make it as simple as possible. a rubber band can be looped around the handle and then the other end looped around the peg on the side of the casing to lock the door in place and create a seal against the front seal and the door (hence making it watertight)...
REMINDER: YOU ARE RESPONSIBLE FOR MAKING ADJUSTMENTS TO THE MODEL TO SUIT YOUR NEED!
