Ikea Olov Leg Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clamp to the Olov table legs to mount stuff like power strips!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
# IKEA OLOV Leg Clamp for a Power Strip (45 mm leg)
A two-piece bolt-together clamp that grips a 45 mm IKEA OLOV desk leg and gives you a flat 80 x 40 mm face to stick a power strip to with mounting tape, or to hang it from by a screw. Made for the Anker PowerExtend 12 Strip (A9191), but any strip with keyhole slots or a flat back will work.
Inspired by [Ikea Olov Legs clamps](https://www.printables.com/model/395312-ikea-olov-legs-clamps)

## What you need
| Qty | Item |
|-----|------|
| 2 | saddle.stl (the half-ring that goes behind the leg) |
| 2 | plate.stl (the front block with the flat face) |
| 4 | M4 x 16 bolts (socket or pan head) |
| 4 | M4 nuts |
| 1 roll | VHB-type double-sided mounting tape |
| optional | 1-2 self-tapping pan-head screws, M4 or #8, **8-10 mm long** (not longer; see below) |
One clamp = one saddle + one plate + 2 bolts + 2 nuts. You need **two clamps** per strip, one per keyhole.
## Assembly

1. Push an M4 nut into each hex pocket on the back of the saddle (the pockets are on the two flange ends). If one is tight, the bolt will pull it in when you tighten.
2. Put the saddle behind the leg and the plate in front of it, flange to flange.
3. Put the bolts in through the large round holes in the flat face, through the plate and saddle flanges, into the nuts. Tighten evenly. The halves start 2 mm apart and close up as you tighten, so they pinch the leg. The clamp grips legs from about 43 to 48 mm.