Micrometer Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clamps a micrometer, leaving your hands free to manipulate the thimble and workpiece.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a straightforward micrometer stand which can be helpful when taking measurements of difficult to hold small workpieces, or repeat readings of a batch of parts. The base includes a small tray.
Requires an M8 nut and hex head screw, approximately 40mm long.
Parts should print in provided orientation without supports. Adding a few extra bottom layers in the slicer can be a good idea to make the base heavier.
The knob should be a push fit on the head of the screw. Drop the nut in the slot in the base, thread the screw in, and thread the ball end onto the screw. You can then use the screw to snap the pad over the ball end.