In-Line Cord Switch for Sonoff ZBMINIL2 - Zigbee - Screw-Free
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-fit case that turns any flat lamp cord into a Zigbee smart switch with a physical rocker. No screws, no neutral
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 1
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Make any lamp with a flat cord smart, and keep a real switch on the cord.
Switch the lamp with the rocker or over Zigbee (Home Assistant, Zigbee2MQTT, Sonoff gateway ...).
The Sonoff ZBMINIL2 needs no neutral wire, so it works on a plain 2-core lamp cord.
Ive also made a 15% smaller switch just like this one here.
Everything is click-in: the lid, the Sonoff, the rocker, the WAGO and the cord locks all snap into place. No screws needed.
Good strain relief: the cord is locked in an S-bend and does not pull out.
Sonoff button and LED are accessible through holes in the back.
Hardware you need for this print:
1 x Sonoff ZBMINIL2 Zigbee Mini Extreme Smart Switch (no neutral required)
1 x WAGO 221-412 splicing connector, 2-conductor (lever nut)
1 x Flat 2-conductor lamp cord, no ground wire (3.45 x 5.71 mm / 9/64" x 7/32") - the cord of your lamp
EU: "flat lamp cable" / "flat twin flex, 2 core" - article name: H03VVH2-F 2 x 0.75 mm2
USA: "lamp cord" / "lamp wire" / "zip cord" - article name: 18/2 SPT-1 stranded copper lamp wire
Printing:
PETG, 0.2 mm (0.008") layers, 0.4 mm (0.016") nozzle, infill 10%, no support. Print every part as it is in the STL file.
Base (floor down), Lid (exported upside down), Cable lock LEFT and Cable lock RIGHT (mirror images - print one of each).