Small In-Line Cord Switch for Sonoff ZBMINIL2 - Zigbee
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-fit case that turns a flat lamp cord into a Zigbee smart switch with a rocker. No screws, no neutral wire.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 1
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Make any lamp with a flat cord smart, and keep a real switch on the cord.
Switch the lamp with the rocker or over Zigbee (Home Assistant, Zigbee2MQTT...).
The Sonoff ZBMINIL2 needs no neutral wire, so it works on a plain 2-core lamp cord.
Everything is click-in: the lid, the Sonoff, the rocker, the WAGO and the cord locks all snap into place. No screws needed.
Good strain relief: the cord is locked in an S-bend and does not pull out.
Sonoff button and LED are accessible through holes in the back.
Ive also made a bigger version of this switch (easier cable management) here
Hardware you need for this print:
1 x Sonoff ZBMINIL2 Zigbee Mini Extreme Smart Switch (no neutral required)
1 x KCD1 rocker switch, ON/OFF, 2 pins, 6A 250V / 10A
1 x WAGO 221-412 splicing connector, 2-conductor (lever nut)
1 x Flat 2-conductor lamp cord, no ground wire (3.45 x 5.71 mm / 9/64" x 7/32") - the cord of your lamp:
EU: "flat lamp cable" / "flat twin flex, 2 core" - article name: H03VVH2-F 2 x 0.75 mm2
USA: "lamp cord" / "lamp wire" / "zip cord" - article name: 18/2 SPT-1 stranded copper lamp wire
Printing:
PETG or PLA, 0.2 mm (0.008") layers, 0.4 mm (0.016") nozzle, infill 10%, no support. Print every part as it is in the STL file.