GMT800 cupholder bracket for GMT900 center seat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket for mounting GMT800 jumpseat cupholders onto the GMT900 jumpseat utilizing existing bolt holes
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Have a GMT900 (2007-'14 Silverado/Sierra) with a center seat, and want a couple more cupholders?
Have a GMT800 (1999-'07 Silverado/Sierra) with the GMT900 jump seat, and want those cupholders back?
Why did I do this?
I have a 2001 Chevy Silverado, reg cab. Stock, it had a center jumpseat which had one storage compartment in the back of the seat. A year ago I swapped in the jumpseat from an '07-'14 Silverado, which has a larger storage compartment in the back of the seat, and a storage compartment under the seat cushion. However its cupholders are on the back of the seat, rather than by the floor.
I got tired of having cups/bottles in my way when rowing through gears, so I added the GMT800 jumpseat's floor cupholders to the GMT900 jumpseat. An afternoon of work in FreeCAD, 5 test prints in PETG, and boom, done. Now I can go back to having my water bottle down low and out of the way, but have extra spots for drinks and stuff if needed.
This bracket allows you to take the GMT800 jumpseat cupholders and mount them to a GMT900 jumpseat. Utilizes existing nuts/bolts on bottom of the GMT900 seat, and common 7mm plastic mount screws found all over the interior of GMT800's.
This is version one, and as of uploading this it hasn't even been installed in my truck for 12 hours.
Will update as needed.
Note: May need to angle the side the cupholder mounts to in a future version, to angle the cupholder against the seat for better fitment.
Printed with SUNLU PETG Pro Black - 5 walls (to give sufficient meat for the interior screws to bit into)
5 top/bottom layers, 20% Gyroid infill