FlagBench - Open Cable Labeling Rest | Standard & Compact

Rest a slack, disconnected cable in two raised open seats and use the centre to apply a label by hand. The front and the area below the cable remain open. Rear marks provide visual centring references for 16 and 24 mm label widths.

Standard is 100 x 60 x 31 mm with a 52 mm clear gap and a 26 mm seat floor. Compact is 86 x 60 x 27 mm with a 38 mm gap and a 22 mm seat floor. These are nominal CAD dimensions.

Two ready-made sizes are supplied in STL and geometry-only 3MF. The standalone OpenSCAD source and matching JSON also include a Wide preset with a 68 mm gap. The matching JSON presets are included in the editable-source ZIP; extract the archive and keep the JSON beside the SCAD.

Choose one model, select your own printer configuration and verify placement and scale. Each 3MF contains one object in millimetres and no printer profile.

This model has not yet been physically printed or used. Actual offline toolpaths were checked for the three source presets with an isolated synthetic recipe, which generated no support or bridge-classified extrusion. Physical cable seating, jacket interaction, finger access, label wrapping, stiffness and stability remain untested. The frame is an open rest without a clamp, intended for slack cable during bench preparation.

The Standard gallery images are mesh renders. The application diagram uses Standard STL sections with an illustrative cable and label to show intended use.

ITALIANO

Appoggio aperto per etichettare a mano un cavo scollegato e lasco. Standard e Compact sono disponibili in STL e 3MF; il sorgente modificabile con JSON comprende anche il preset Wide.

Non ancora stampato o usato. Appoggio del cavo, accesso delle dita, applicazione dell'etichetta e stabilita reali sono da provare. Il supporto non ha un morsetto; cavo ed etichetta nello schema sono illustrativi.