1 / 4
End Cap for 2-Pole Pin Busbar (Gewiss GW96989) — zdjęcie 1
1 / 4

End Cap for 2-Pole Pin Busbar (Gewiss GW96989)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Push-on end cap for a 2-pole pin busbar (Gewiss GW96989, 63 A). Open bottom, tapered legs grip the bar. No supports.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
4
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Printable replacement for the original busbar end caps (Gewiss GW96964) for the 2-pole pin busbar Gewiss GW96989 (63 A). The original caps are surprisingly expensive, and these print in a few minutes.

Design

  • Cross-section is an upside-down "U" with no bottom face, so the busbar can still sit fully down in the breakers.

  • The lower part of the walls is tapered inwards, so the legs press against the busbar and hold the cap in place.

  • Inner height 13.5 mm (busbar is about 14 mm), so the legs don't touch the breakers.

  • Push-on depth 7 mm - less than the distance from the end of the busbar to the first pin.

Files

  • busbar_endcap_t1 - recommended. Inner width 9.5 mm at the top, 7.5 mm at the bottom (taper 1 mm per side). Overall 11.9 x 14.7 x 8.6 mm. Fits snugly without deforming. Use this one for PLA.

  • busbar_endcap_t1.5_tight - taper 1.5 mm per side (6.5 mm at the bottom). Grips harder, but the legs spread a little. OK for PETG; not recommended for PLA, because PLA creeps and can crack under constant tension.

Both were test-fitted in PETG on a real GW96989 busbar.

Printing

  • PLA or PETG, 100% infill.

  • Print standing on the closed end, no supports.

  • Print 1-2 test pieces first - other busbar brands may have slightly different profiles.

Not affiliated with Gewiss; the brand and part numbers are mentioned only to describe compatibility.

Tagi