End Cap for 2-Pole Pin Busbar (Gewiss GW96989)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Push-on end cap for a 2-pole pin busbar (Gewiss GW96989, 63 A). Open bottom, tapered legs grip the bar. No supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Printable replacement for the original busbar end caps (Gewiss GW96964) for the 2-pole pin busbar Gewiss GW96989 (63 A). The original caps are surprisingly expensive, and these print in a few minutes.
Design
Cross-section is an upside-down "U" with no bottom face, so the busbar can still sit fully down in the breakers.
The lower part of the walls is tapered inwards, so the legs press against the busbar and hold the cap in place.
Inner height 13.5 mm (busbar is about 14 mm), so the legs don't touch the breakers.
Push-on depth 7 mm - less than the distance from the end of the busbar to the first pin.
Files
busbar_endcap_t1 - recommended. Inner width 9.5 mm at the top, 7.5 mm at the bottom (taper 1 mm per side). Overall 11.9 x 14.7 x 8.6 mm. Fits snugly without deforming. Use this one for PLA.
busbar_endcap_t1.5_tight - taper 1.5 mm per side (6.5 mm at the bottom). Grips harder, but the legs spread a little. OK for PETG; not recommended for PLA, because PLA creeps and can crack under constant tension.
Both were test-fitted in PETG on a real GW96989 busbar.
Printing
PLA or PETG, 100% infill.
Print standing on the closed end, no supports.
Print 1-2 test pieces first - other busbar brands may have slightly different profiles.
Not affiliated with Gewiss; the brand and part numbers are mentioned only to describe compatibility.
