1 / 3
Motor Cooling Fan Impeller 186 mm, 28.5 mm Bore — zdjęcie 1
1 / 3

Motor Cooling Fan Impeller 186 mm, 28.5 mm Bore

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement cooling fan for an electric motor: 186 mm, 10 radial blades on a conical disc, hub bore 28.5 mm.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
2
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Replacement cooling fan (impeller) for the electric motor of a construction machine - as far as I know, a plaster spraying / mortar pump. I don't know the exact make or model of the motor: I was given a broken fan and modelled this one from it.

Dimensions

  • Outer diameter: 186 mm

  • Overall height: 39 mm

  • 10 radial blades on a conical disc (about 4 mm thick); blade thickness about 2 mm

  • Hub: outer diameter 49 mm, length 20 mm

  • Bore: 28.5 mm, straight through. No keyway and no set screw.

Mounting

The fan is a tight press fit on the motor shaft. On the original motor the shaft end is knurled, and the knurling bites into the plastic and keeps the fan from turning. Press it on evenly (warming the hub a little helps).

Measure your shaft before printing - if the fit is too loose or too tight, scale only X/Y slightly in the slicer.

Printing

  • Printed in PETG (250 °C nozzle, 70 °C bed) on an Ender-3 V2.

  • Layer height 0.2 mm, infill 50%.

  • Print with the wide side of the cone on the bed; supports from the build plate only (under the hub).

  • Print time about 15 hours, about 48 m of filament.

PETG or another heat-resistant material is recommended - the motor housing gets warm. Check balance and that the blades don't touch the fan cover before running the motor.

If you recognise the machine or motor, please leave a comment so others can find it.

Tagi