E3NG_SpriteProMount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for the Creality Sprite PRO for the E3NG project. I couldn't find one, so I made it myself.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
DON'T USE THIS YET. Wait for my revised model. After mounting and testing further I find this to be too flexible for my liking, so I am going to redesign it slightly to fix this.
This is a Sprite Pro mount for the E3NG project. While building my E3NG I searched for a proper mount for my Sprite Pro and could only find mounts for the Sprite extruder, not the whole Sprite Pro setup, and I really wanted to put it to use since I have two of them and was converting my Ender 3 Pro anyway.
Since there is really not much heat generated this can be printed in PETG, but I recommend using the same settings as all the other E3NG parts just for consistency. If you're running a full enclosure and print higher temperature parts, then I would print this in ABS or ASA instead.
This mounts using four M3 x 6mm SHCS screws through the four countersunk holes and into the m3 heat set inserts in the E3NG gantry mount, and uses the original screws to mount the Sprite Pro to the mount itself.