E3NG_SpriteProMount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mount for the Creality Sprite PRO for the E3NG project. I couldn't find one, so I made it myself.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 8
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a Sprite Pro mount for the E3NG project. While building my E3NG I searched for a proper mount for my Sprite Pro and could only find mounts for the Sprite extruder, not the whole Sprite Pro setup, and I really wanted to put it to use since I have two of them and was converting my Ender 3 Pro anyway.
Since there is really not much heat generated this can be printed in PETG, but I recommend using the same settings as all the other E3NG parts just for consistency. If you're running a full enclosure and print higher temperature parts, then I would print this in ABS or ASA instead.
This mounts using four M3 x 6mm SHCS screws through the four countersunk holes and into the m3 heat set inserts in the E3NG gantry mount, and uses the original screws (or four M3 x 6mm on the side and two M2 x 10mm top/rear) to attach the Sprite Pro to the mount itself.
NOTE: Remove the original cable mount from the Sprite Pro extruder, and use those screws to attach the extruder to the top of the mount. I will be designing a cable support that attaches to the E3NG hotend gantry and will upload that later and link it here as well.
The cable mount can be found here: