1 / 5
Hooch 90mm End Cap 1/2" BSP Bung - O-Ring Seal, Screwdriver Slot — zdjęcie 1
1 / 5

Hooch 90mm End Cap 1/2" BSP Bung - O-Ring Seal, Screwdriver Slot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slotted G1/2 (1/2 inch BSP) bung with an O-ring face seal for the Hooch 90mm end cap outlet. Prints without supports.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

1/2" BSP (G1/2) bung with O-ring seal & screwdriver slot

A threaded drain plug for the Hooch 90mm "1/2 inch BSP Tap End Cap" (the 90mm round pipe end with the G1/2 outlet). Screw it in to close the outlet, back it out when you need to drain the channel.

How it seals

The seal is a face seal: an O-ring sits in a groove around the thread base and is squeezed against the flat outer face of the end cap. The thread only has to hold the plug in place, so it does not need to be perfect. Tested with an 18 x 2.5 mm O-ring, which fits well. The groove is sized for a 20 x 2 mm ring by default; other sizes are one line in the OpenSCAD file.

Features

  • G1/2 (BSPP) male thread, 14 TPI, 1.814 mm pitch, 11 mm long, with a lead-in chamfer. The profile was measured from the cap's own female thread.
  • 28 mm flange with a full-width slot (2.2 mm wide, 4 mm deep) so you can drive it with a flat screwdriver or a coin and really tighten it.
  • Thick (2.5 mm) solid section between the slot and the O-ring groove, so it prints cleanly even on a 0.8 mm nozzle.

Which file?

  • clr0.15 standard - start here.
  • clr0.25 loose - if the standard one is stiff (printed threads often come out slightly fat).
  • clr0.10 tight - only for printers that print threads slightly small.
  • .scad - parametric source: clearance, O-ring size, slot size, flange size.

Printing

  • Flange flat on the bed, thread pointing up, slot face down. No supports needed.
  • PETG or ASA recommended, 4+ perimeters, 100% infill, 0.2 mm layers or finer for the thread.
  • Printed on a 0.8 mm nozzle for the photos; a 0.4 mm nozzle will give a crisper thread.

Tested

Fit-tested on the Hooch 90mm 1/2 inch BSP Tap End Cap: the thread engages well and the O-ring face seal seals well (18 x 2.5 mm O-ring), and the plug can still be backed out to drain the channel. See the photos of it fitted to the end cap.

Notes

End cap by Hoocho - this is a separate accessory part, not a modification of it.

Tagi