InMoov Petit (Part 5 of 10) Hips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
InMoov Petit (Part 5 of 10) Hips
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 5
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Engineering
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here are the Hip parts to connect into InMoov Petit's upper torso panels.

It uses a Standard Generic MG946R Servo for upper part (highly recommended to use Metal Geared servos throughout) and a Standard Generic MG90S for the lower part.
Here you see the left leg , MG946R Servo is placed inside the Servo holder (Green) note that there is a a baseplate (Red behind) which need to be glued to the baseplate , the servo cradle (Red) is pinned in place with some spare filament (White) , the cradle is glue attached (also with some white filament) to the lower MG90S Servo holder (Pink). The lowest (Orange) part is the eventual attachment point for the upper thigh.
This exploded view shows the way to assemble the individual parts.




This exploded view shows the way to assemble the individual parts.

Please note you need 2x of the 20261112_Servo_Horn_Blanking_Pivot's , these are used as pivot points , top right of the above picture you see one that is glued into the back torso part (Green) the pivot pin (Filament) passed through the hole and into the back of the top servos (Red) plate,
The bottom 20261112_Servo_Horn_Blanking_Pivot hides inside the Thigh mount bracket (Orange) and a filament pin poked through sticking into the base of lower servo mount (Pink).