1 / 4
Power Brick Mount for Ugreen Revodok Pro 314 — zdjęcie 1
1 / 4

Power Brick Mount for Ugreen Revodok Pro 314

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder/mount for the 140W power supply brick of the Ugreen Revodok Pro 314 (Sku: 85489) and probably similar models.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
11
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Share Alike

Holder/mount for the 140W power supply brick of the Ugreen Revodok Pro 314 (Sku: 85489) and probably similar models.

The model holds the power brick off the surface to allow air circulation (air gap).

When you place your power brick, always make sure that it is exposed to enough fresh air that it does not overheat.

If you like this design, please consider leaving a ♥heart. Thanks!

----------

Brick Measurements

  • Length x Width x Thickness: 100 x 70 x 31 mm

  • Corner radius: 10 mm

----------

Printing

Print two main parts and one spacer. Use the spacer during installation to achieve the correct placement.

  • Nozzle: 0.4 mm

  • Filament material: PETG*

  • Layer height: 0.25 mm

  • Supports: Yes, organic/tree supports for the clamps

  • Infill: 20 % Grid

  • Perimeters: 2

*) PLA is too brittle and its interlayer bonding is not strong enough. Also, it might get soft when the brick heats up.

If you use the 2D-printable template as a reference, make sure not to scale it during the print process. The two reference crosses should check out 20 x 20 mm.

----------

Materials

  • [4x] Screw, 2.5 mm diameter, 5 mm head

  • (optional) [4x] Washer, <= 10 mm outer diameter, if the screw has a countersunk head

Tagi