Power Brick Mount for Ugreen Revodok Pro 314
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder/mount for the 140W power supply brick of the Ugreen Revodok Pro 314 (Sku: 85489) and probably similar models.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 11
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
Holder/mount for the 140W power supply brick of the Ugreen Revodok Pro 314 (Sku: 85489) and probably similar models.
The model holds the power brick off the surface to allow air circulation (air gap).
When you place your power brick, always make sure that it is exposed to enough fresh air that it does not overheat.
If you like this design, please consider leaving a ♥heart. Thanks!
----------
Brick Measurements
Length x Width x Thickness: 100 x 70 x 31 mm
Corner radius: 10 mm
----------
Printing
Print two main parts and one spacer. Use the spacer during installation to achieve the correct placement.
Nozzle: 0.4 mm
Filament material: PETG*
Layer height: 0.25 mm
Supports: Yes, organic/tree supports for the clamps
Infill: 20 % Grid
Perimeters: 2
*) PLA is too brittle and its interlayer bonding is not strong enough. Also, it might get soft when the brick heats up.
If you use the 2D-printable template as a reference, make sure not to scale it during the print process. The two reference crosses should check out 20 x 20 mm.
----------
Materials
[4x] Screw, 2.5 mm diameter, 5 mm head
(optional) [4x] Washer, <= 10 mm outer diameter, if the screw has a countersunk head