1 / 2
DS4 Phone Holder for Galaxy S24 Ultra – Self-Adjusting Spring Clamp (ps playstation dualshock 4) — zdjęcie 1
1 / 2

DS4 Phone Holder for Galaxy S24 Ultra – Self-Adjusting Spring Clamp (ps playstation dualshock 4)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Snap-on ds4 mount that holds a Galaxy S24 Ultra, balanced over the grip, Self-adjusting clamp.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Public Domain

Description

A remix of @Momoskimomoski’s DS4 phone holder. The controller clip is unchanged, so it snaps on exactly like the original. Everything above it is redesigned

What’s different

  • Balanced: the phone’s center sits right over the column, which sits over the stiffest part of the clip. Almost no leverage on your wrists or the clip.

  • Higher and closer: the phone floats about 30 mm above the face, tilted 10° toward you, so every button stays reachable.

  • Self-adjusting clamp: the phone sits on two angled ledges and centers itself. Variations in case size and print tolerance are absorbed by the spring, so it doesn’t need a perfect fit.

  • Clearance for a phone grip: the cradle dips in the middle to clear a PopSocket-style grip (up to about 42 mm wide and 7 mm tall when collapsed).

  • Tapered column and spring: material is placed where the load is, and every corner is rounded, which matters for PLA.

Fit
Made for the S24 Ultra in a case: about 80–82 mm wide and 9.4–11 mm thick. A bare phone will be loose.

Use
Clip it onto the controller. Tuck the phone’s bottom edge under the near hook, then press the top edge down until the jaw snaps over it. To remove, pull back the thumb tab on the top jaw. Don’t leave the phone clamped when you’re not using it.

Printing

  • Orientation: flat, as exported. Every spring and hook then flexes along the layers.

  • Material: PLA works. PETG lasts longer, because PLA slowly loses grip under constant load and softens in heat.

  • Walls: use enough (about 6) that the springs print solid, with no infill inside them.

  • Seam: put it on the back of the column, not on the springs.

Other phones and cases
The included remix.py script generates the model from parameters (fit range, tilt, height, grip size, spring preload). Edit the numbers and run it to fit another phone. It needs the original STL in in/orig.stl.

Tagi