1 / 1
Asrock Deskmeet B660 Front with Ventilation — zdjęcie 1

Asrock Deskmeet B660 Front with Ventilation

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modded Deskmeet Front with Ventilation-Slits.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

A new Frontplate for the Deskmeet B660. The other Deskmeet Variants (X300, X600, B760) will probably work, too.

How it works depends on the coolerstyle of your GPU. My GPU has his coolings fins running lengthwise along with it. Therefore the hot air is is pushed out at the end of the GPU. If they are positioned perpendicular, the effect may be not as good.

Info:

Printed in PTEG. PLA will warp over time. Maybe HT-PLA will work. But I recommend PTEG, ASA or ABS.

You have to remove the small metal bracket in the left side of the case, around thefront-IO. Its just mounted with 3 or 4 small metal bridges.

The front panel has four pockets for magnetic tape. (WxH) 21mm x 2mm

It fits on mine B660 quite well, but depending if Asrock has moved the Front-Ports a bit, you should measure first. FreeCad File is here, too.

Tagi