1 / 9
SpacePi Bottom Shelf Support Ski — zdjęcie 1
1 / 9

SpacePi Bottom Shelf Support Ski

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Support the bottom drawer when fully extended over the edge of a shelf or table

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

If you're using this "microwave stand" for your Creality SpacePi dryers on a shelf that isn't long enough to support the lower shelf at full extension then this is for you. It fits underneath the lower shelf and supports the drawer even when fully extended over the edge of a table. I found that one in the center is enough to keep the shelf stable.

Requires a single M3 screw to hold the two parts together. It can be M3x6, M3x8, or M3x10.

It is intended to be a tight fit into the curled over portion on the bottom of the shelf. You can either preassemble the two parts and twist it into place or insert the two pieces separately and slide them together to assemble.

A test part has been added to the files to check the fit in your shelf before printing the entire thing.

I recommend printing with 3 perimeters and at least 15% infill. Any rigid filament type will work (don't use TPU). No supports required.

I added put some UHMW tape (Ultra-High Molecular Weight Polyethylene tape) on the bottom of mine to help it slide.

Tagi