ASUS Ascent GX10 Spacer For Full Sized NVMe
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser that allows for a larger NVMe SSD to be installed in an ASUS Ascent GX10 computer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This adapter allows you to add a physically larger size NVMe SSD to an ASUS Ascent GX10 server. The standard NVMe is an M.2 2242 and the pocket that it fits into forces that size. Larger physical formfactor NVMe drives have typically been easier to get and a bit cheaper than the 2242 size. This adapter allows you to use a physically larger NVMe that you already have or a cheaper-per-MB drive that won't fit in the case as-is. This is especially important because the ASUS Ascent base model, with only 1TB is one of most expensive NVIDIA GB10 computers and this allows you to expand its capacity for much less money than buying a 2TB or 4TB model.
There is no technical reason that you can't run a larger sized NVMe such as a 2260 or a 2280. This fixes that by giving you an extra 9mm of space. It uses the original base plate and just extends the space between the internal components and the base plate.
NOTE: I am not responsible for any damage you may cause to your very expensive computer. Modding hardware is a personal decision. Proceed at your own risk.
You'll need:
Thin double sided tape or Kapton tape (do not use foam double sided tape, it's too thick)
Metallic finish spray paint (optional)
Instructions:
I suggest printing in PETG or PLA. I finished mine with a metallic silver/aluminum spray paint to match the case of the ASUS Ascent GX10.
Remove base plate
Remove plate covering the NVMe and its 4 screws
Cut the new adapter so that it is now the size of a 2244 M.2 NVMe
Install the adapter
Re-install the protective shield over the NVMe. (Note that one of the screws will not be installed because the new ribbon cable blocks the hole).
Fold the cable gently (no sharp kinks) in the pattern shown in the photos.
Adhere the adapter to the internal plates using thin double sided tape or Kapton tape
Install your cloned (use dd or other method) large form factor NMVe
Install the 3D printed base. There is an "F" and a "B" for front and back orientation.
Install the original base plate with 4 x 12mm long M2.5 countersink head bolts
I suggest using a low-profile heatsink as pictured. Once booted, you'll have to resize the filesystem with GParted or some other utility. Note: Use a true Thunderbolt adapter to do the copying. If your drive shows up as /dev/sd* and you see the brand of the adapter and not the brand of the drive in dmesg output, you've got the wrong type of adapter.
Good luck and have fun!
Also on Thingiverse