Akimbo Hooks for 20mm Picatinny Stock Att. Point (SS BreakBarrel-MegeBigShock) Mk 1.0
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
the X-SHOT BreakBarrel AKIMBO PRIME HOOKS These are meant to be used w/ GEMENEYE's Picatinny Stock Point
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I present to you, the X-SHOT BreakBarrel AKIMBO PRIMING HOOKS
These are meant to be used w/ GEMENEYE's Picatinny Stock Point to be able to mount my hooks.
https://www.printables.com/model/1813259-x-shot-break-barrelspinshot-picatinny-stock-point
The only blaster modification that’s needed is to file down the square nubs on the T-pull. Just file them down to be flush with the round parts. (SEE PICTURE 4)
To account for any variation in your print settings & tolerances you may have to enlarge the part by 2 or 3% to get a good snug friction fit. I may add a bolt and nut holes to tighten to fit any pic variation. Mine had good friction at 102.5%
Pro's
Dual wield X-Shot break-spin-barrel-shots
Minimal "shell cutting" or T-pull filing
Con's
Hooks make the "break hammer" hard to reach. might have to remix the hammer to have a side paddle for my thumbs like Leedle's HammerHead.
sticks a little far out the back. If anyone with more CAD experience can remix the stock point to replace the picatinny with these hooks to minimize stick out. You would just have to make the design print with the proper layer orientation to keep the hooks strong.
