1 / 1
Clip-On Shroud for Vornado Zippi Fan — zdjęcie 1

Clip-On Shroud for Vornado Zippi Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Do you own a Vornado Zippi fan? This shroud stops people & pets from getting fingers/paws/tails in the blades!

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
3
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The Vornado Zippi is a good little fan. It has cloth blades and thus doesn't need a cover of any kind, but it still moves a decent amount of air for a personal desk fan. I have multiple Zippis for home, work, and workshop (this is not an ad, I swear). However, when someone (such as a cat or an unobservant human) doesn't know it's there and sticks a finger/paw/tail through the spinning blades, they get scared and panic, often causing a mess as they freak out and run.

I made this shroud to show humans there's something there, and to keep my lounging cat's tail from flipping into the blades. It clips onto the body of the Zippi nice and snug and seems to slightly increase airflow (emphasis on "seems," because I have no way of measuring that).

It just BARELY fits on the build plate of my MK4S, so I have two versions for you.

Zippi Shroud with brim.stl
 - Because the shroud ring is so thin, I added a narrow brim on the inside of the ring for those of us whose printer build plates only go to 210mm in at least one dimension. No brim on the outside means the shroud can be big enough to fit the Zippi.

Zippi Shroud.stl
- Add your own brim (or don't! I'm not the boss of you!)

Dimensions:
X: 209.76
Y: 209.57
Z: 62.12
Best with three perimeter layers, Supports can be whatever style you prefer.

IMPORTANT NOTES:

  • This thing will be VERY snug on your Zippi! It's like this to prevent rattling.

  • Get the bullet-shaped tab into the Zippi's screw hole first, then pull the tabs into the vent slots one at a time.

    • This may sound crazy before you try it, but it'll make sense when you go to put this thing on and it doesn't seem like it will fit.

    • It will fit! It just takes some convincing.

    • The tabs go into the same height vent slots on each side. The horizontal arms of the shroud will be fully horizontal if you got the tabs in the correct slots.

  • Doesn't need much infill, 15~20% is fine.

Tagi