1 / 2
Adafruit NeoKey 1x4 under-desk angled mount — zdjęcie 1
1 / 2

Adafruit NeoKey 1x4 under-desk angled mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An under-desk housing for the Adafruit 1x4 NeoKey keypad with enough space for a TRRS Trinkey underneath

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a basic little housing for an Adafruit NeoKey 1x4 along with enough space for a TRRS Trinkey or similarly small microcontroller. These work together as a remote for my KVM switch which is tucked out of the way. I'm using Kailh box key switches and clear keycaps, also sourced from Adafruit. This assembles with snap tabs and uses two #8 wood screws to mount to the desk.

I printed PLA with 6 walls and 15% infill, no supports, 0.4mm nozzle. After printing, flex the spring tabs on the face plate to free them up, as they print with a single line to support off the layer below.

Tagi