Raspberry Pi and 5 Inch Display Case Back with Tab for Husky portable work table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I added a tab that fits in the slot on the worktable I'm using for my printer enclosure.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 1519
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I added a tab to the back of the Raspberry Pi and 5 Inch Display Case by Neddy. It was the easiest way to mount to the table I have my printer enclosure on.
PETG 0.2mm or 0.3mm layer height.
I was unsure how the overhangs would be handled at 0.3, so mine is in 0.2mm layer height.
Print with the tabbed back on the build plate to avoid needing supports. I also tried to match all three openings for the Raspberry Pi. One of the USBs was not fully exposed, so I widened it a bit.
NOTE: This is only the back of the case. I didn't need to modify the front for this additional mount. Please see the original model for the front piece.