GepRC MX3 Sparrow VTX Antenna Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found that when using a 20mm Flight Stack with a UFL Antenna in the GepRC MX3 Sparrow frame that it tended to come…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I found that when using a 20mm Flight Stack with a UFL Antenna in the GepRC MX3 Sparrow frame that it tended to come straight out the back right in line with the props and it would hit them occasionally. So I drew this Antenna holder up in Fusion 360 to plug into the existing carbon fibre antenna mount and accept a 2mm antenna cable to bend it up out of the way.
Should also work with any standard SMA/RP-SMA hole in 1.5mm carbon plate. It slips over the antenna cabler and clips snuggly into the carbon plate. Should be short enough to accept clover leaf and dipole UFL connector antennas.
Print Settings
Printer:
Turnigy Fabrikator Mini Mk2
Rafts:
Yes
Supports:
No
Resolution:
0.2mm
Infill:
20-30%
Notes:
I printed in ABS but it will probably work fine in PLA etc.
Category: R/C Vehicles