Pegboard holder for Harbor Freight Pittsburgh 1lb dead blow hammer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple pegboard holder for 1lb Harbor Freight Pittsburgh-branded dead-blow hammer. Since Harbor Freight tools are…
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 159
- Wydruki
- 1
- Wyświetlenia
- 687
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple pegboard holder for 1lb Harbor Freight Pittsburgh-branded dead-blow hammer.
Since Harbor Freight tools are usually a crappy copy of some better tool manufacturer's design, it's very likely that other 1lb dead-blow hammers will fit this as well. Let me know if you print it for something else and it fits.
Another design for what looks to be the same hammer is found here: https://www.thingiverse.com/thing:3105785 Of course mine is vastly superior but in case you don't agree, check that one out.
Print Settings
Printer:
Prusa MK3S
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
20%
Filament:
eSun PLA+
white
Notes:
Can be printed without supports but the underside of the upper pegs will be a bit rough, especially when printed at coarser layer heights. As these are in the pegboard and not visible that's not a big problem, and that's how I usually print. Adding supports doesn't slow down the print much, so it's your call.
Category: Tool Holders & Boxes