Pegboard mount for safety glasses
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep safety glasses (or smaller normal glasses) handy on conventional round pegboard.
- Ocena
- 4,556 / 5
- Polubienia
- 62
- Pobrania
- 429
- Wydruki
- 9
- Wyświetlenia
- 1320
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got new safety glasses and needed to keep them somewhere safe. I use pegboard, so that was the perfect place. I looked at a bunch of the options available here (see below for a list) but none of them were quite what I wanted - most hold the glasses by the bridge, which might not work so well with these as they have rubber nose pads. So I created my own. The holder is quite long as these safety glasses wrap around quite a bit and wind up being pretty deep.
This is designed for 1" pegboard with 1/4" holes.
Print instructions
Prints with no supports. You can do supports for the upper pegs but if you don't it'll just be a little messy on the underside of the top pegs, which shouldn't cause too much trouble. If it interferes with the holes, it's an easy cleanup.