Ender 3V2 Damper Feet (Soft Springs)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is a lot springier than the original. It also fits onto the rubber feet on my Ender 3 V2 (better). In…
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 83
- Wydruki
- 1
- Wyświetlenia
- 797
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Version 2 available: Ender 3V2 Damper Feet (Soft Springs) von AaronLK
As far as I can remember my engingeering-courses the machine should sit on springs as soft as possible to reduce vebrations from/to the environment. Standing on a IKEA Lack table these springs make a significant defference in noise especially while printing with high speed and acceleration.
With even softer springs my PLA deformed after some days. This design seems to be a good compromise. When using them inside an enclosure you should not use PLA as it will easily deform at higher temperatures.
Note: The printer can shake quite a lot. This may look scary but is absolutely fine and wont affect print-quality.
In order to install a new motherboard-cover I additionally used these riser feet (https://www.thingiverse.com/thing:4665097).
Edit Nov./2022:
As was requested I have added a version to fit the feet of IKEA Lack tables. I can't verify if it is strong and stiff enaugh. Please let me know if not or make a remix yourself.
Print Settings
For best results print with perimeters only.
Dont use PLA when using inside an enclosure as it will deform quite easily.