Vertical Solder Spool holder v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Solder Spool holder that keeps the spool from moving around
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 292
- Wydruki
- 3
- Wyświetlenia
- 1278
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update! New V2 model. I have updated the models to the new v2 model. It has a round base to keep the solder from accidently binding under the base in one of the corners and has a thicker top portion to keep it from binding under it as well.
There are plenty of Solder Spool holder models that hold the spool horizontally, but I wanted one that kept it upright, so I designed this one.
To assemble, you need one 8x22x7 mm bearing (standard skateboard wheel bearing) and a m3 x 16mm machine screw. Click the bearing into the bottom piece and then click the top piece down onto it. It should be a snug fit, but not insanely tight. Then use the washer and m3 screw up through the bottom into the center pin on top. I would recommend adding some rubber feet to the bottom for additional grip to your table top.
I have included the .step file for easier remixing or if you need to adjust that top spool pin. It's 18mm in diameter which is perfect for 1 pound spools of Kester solder.