Gloomhaven Flying Monster Standee Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser used with either original monster stand, or a printed one, to indicate a monster has flying.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 90
- Wydruki
- 1
- Wyświetlenia
- 565
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
In my infinite desire to print ALL the things for my Gloomhaven campaign, I came across this amazing standee for monsters. I also found this riser for flying monsters, but I didn't like the separate component layout of the original design, and the remix this is based on was too thick in the base to fit in the monster standee, so I added bevels to the base so it can fit.
Unfortunately, this means the base is only about 1.5mm thick, so printing with a brim is highly recommended.
Supports are not necessary as long as you print at 0.16mm layer height, otherwise, the bottom of the top section will come out a bit ugly.