Gloomhaven Flying Monster Standee Riser
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.64 – €0.79 net (excluding VAT)
For file: Modified Flying Standee.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.71 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 1 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Riser used with either original monster stand, or a printed one, to indicate a monster has flying.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 90
- Makes
- 1
- Views
- 565
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution
In my infinite desire to print ALL the things for my Gloomhaven campaign, I came across this amazing standee for monsters. I also found this riser for flying monsters, but I didn't like the separate component layout of the original design, and the remix this is based on was too thick in the base to fit in the monster standee, so I added bevels to the base so it can fit.
Unfortunately, this means the base is only about 1.5mm thick, so printing with a brim is highly recommended.
Supports are not necessary as long as you print at 0.16mm layer height, otherwise, the bottom of the top section will come out a bit ugly.