1 / 29

Raspberry Pi Syncthing Case for Offsite Backup!

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Snafky

@Snafky_7584

I created a Full printed enclosure for a raspberry pi (4 in my case).

Ocena: 0 / 5
Polubienia: 11
Pobrania: 41
Wydruki: 0
Wyświetlenia: 1154
Oceny: 0

Aktualizacja u źródła: 12 kwi 2022

Informacje o modelu

Źródło: Printables
Kategoria: Computers
Licencja: Creative Commons — Attribution — Noncommercial — Share Alike

Szczegóły Pliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (23)

I created a Full printed enclosure for a raspberry pi (4 in my case).
The main purpose for me it that i put SyncThing on this installation. This box can be put on a internet anyware you want and the drive will sync with your other drives.
If you put it somewhere out of your house you have a offsite backup for very low running costs ;-)

Main storage is on a single 3.5 HDD over a fast USB3.1 interface using the:
EW7018 USB 3.1 Gen1 (USB 3.0) to 2.5/3.5 inch adapter.

There is a single 140mm fan in front for cooling.

The unit is powered by a reliable Mean-Well-LRS-50-12-power-supply-12V-50W.
Using some buck converters I convert the voltage to the suitable level for the Pi and Fan.
The parts are stacked on each other so it can be build in blocks.

Note that the cover can be printed in one piece but i would not advice this.
Because can be quite hard because of possible warping.
Printing in three pieces is perhaps better.

In the pictures is some white residue on the cover this is because of 3dLac that i used for binding.

Enjoy and please like!

All is hold together by M2 Philips screws

Print instructions

Advised not to print the cover in one piece

Tagi

meanwell raspberry raspberrypi raspberrypicase raspberrypi4 thingiverse computercase raspberrycase backup computerhousing ewent offsitebackup syncthing