Semi Permanent Cable Guide / Holder for desk or nightstand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable holder/guide that holds a cable captive and is meant to be attached to a desk or nightstand via a command strip.
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 161
- Wydruki
- 3
- Wyświetlenia
- 747
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I hated having to reach down to the floor to grab my phone charger's cable every night. This keeps it handy at the top of my nightstand.
This is meant to be semi-permanent, once the dovetail slides together the interference between layer lines locks it together. It can be separated, but takes a fair amount of force depending on your print quality. If its too easy to slide apart a dot of CA glue will take care of that. You should print this with a material that you can achieve a high level of detail, for me that was PLA. Its sized to accept a poster sized command strip for mounting.
Print settings:
I suggest a brim due to the small surface area touching the bed.
Supports are required under the male dovetails.
Smaller layer height helps clean things up if you are having trouble with the small details.
Use an aligned seam.
The .3mf file has all the appropriate setting that you can carry over to your printer in prusaslicer.
Fusion360 file added for anyone that wants to modify to suit their needs.