1 / 2
why would you print this vase mode pen cup
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I mean... did you see it? It's a lot
- Ocena
- 5 / 5
- Polubienia
- 198
- Pobrania
- 1534
- Wydruki
- 23
- Wyświetlenia
- 5542
- Oceny
- 18
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 23) (Komentarze: 28)Remiksy (0)Kolekcje (304)Powiązane
It doesn’t print fast. It uses too much filament. It takes up a lot of space. It does a barely passable job holding pens. But it’s swirly and you love it, don’t you? Yeah… I know what you like. Go ahead, I know you’re gonna print it.
Print instructions
This is vase mode (the best mode) cup. While that’s the only real requirement, here are the setting I used:
- Spiral vase mode / Spiralize outer contour: turn this on, this is how the whole magic works
- Line Width: 0.7mm (but 0.5mm or 0.6mm should work as well)
- Layer Height: 0.3mm (not necessarily required, but I like to keep things fast)
- Bottom Thickness / Bottom Layers: 1.2mm (e.g. 4 layers at 0.3mm layer height)
- Wall speed: 30mm/s (you are pushing a lot of plastic, so a slower speed is best, though if you are confident in your hot end you can go faster)
- Printing Temperature: +10 degrees hotter than your usual temperature
- Flow: 110% (because why not)
Note
The model in the photos was printed on an Elegoo Neptune 2 with a 0.4mm nozzle in Polymaker PolyTerra arctic teal PLA.