USOS Seaview in 3 pieces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I sectioned it in three pieces and made a center section without periscopes so you need no support. I printed them on…
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 384
- Wydruki
- 3
- Wyświetlenia
- 1528
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I sectioned it in three pieces and made a center section without periscopes so you need no support. I printed them on end. 200% gave me a 17 and 3/4 inch model when assembled. It came out good. I printed it with direct drive and a .6 nozzle. It took 15 hours. I gave pictures of how it printed on the machine so you can see the set-up. The pin was tight, I took the front and middle section bunched up a towel against my chest and pulled it together with 2 hands, I started the pin in the tail and pulled it into the front 2 sections. The tail is not up to taking that kind of pressure and will bust the fins.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Infill:
20
Category: 3D Printing