I stink therefore I am
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bathroom window fan rig setup thingie. I glued the block and split separately to the frame. Do your best and make them…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
Bathroom window fan rig setup thingie.
I glued the block and split separately to the frame. Do your best and make them square with quick epoxy until it thickens up, about 5 min
Center the block and make the split offset a bit towards the bathroom side.
I didn't put a ton of design time into this.
I made this to work with halilgrgn51's https://www.thingiverse.com/thing:4601769 connector.
The frame is intended to go on the outside. It is a pain to assemble and brumster's may work better on the inside of the 51's tabs. Also, there is a angled ledge on the tabs that may get in the way. They can be easily snapped off after printing if needed.
Category: Bathroom