I stink therefore I am
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bathroom window fan rig setup thingie. I glued the block and split separately to the frame. Do your best and make them…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 247
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
Bathroom window fan rig setup thingie.
I glued the block and split separately to the frame. Do your best and make them square with quick epoxy until it thickens up, about 5 min
Center the block and make the split offset a bit towards the bathroom side.
I didn't put a ton of design time into this.
I made this to work with halilgrgn51's https://www.thingiverse.com/thing:4601769 connector.
The frame is intended to go on the outside. It is a pain to assemble and brumster's may work better on the inside of the 51's tabs. Also, there is a angled ledge on the tabs that may get in the way. They can be easily snapped off after printing if needed.
Category: Bathroom