Drill Guide for Mating Holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following: 1)…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 442
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following:
1) Measuring things;
b) Using a drill;
iii) Consistent lists.
But you have a 3D printer...
FEAR NOT, Stu has got your back. Hole Guide Part 1 is designed to use a 25mm flat blade to put a hole through a scaffold board, and then a 10mm drill bit to drill a hole in the end which goes through the middle of the 25mm hole.
Part 2 is designed to fit over the end of a second board and let you drill a companion 10mm hole. All you then need to do is bolt it up, and you are halfway closer to not sleeping on a mattress on the floor.
SCADs are included so you can remix them for any hole/wood you might have.
Print instructions
I personally used 0.2mm and roughly 30% infill...but i'm certain that part isn't all too important. You will need to support the guides however.
When I printed them, I oriented a flat side down. I'd suggest you do the same!